Teflon Grease High Load and High Speed ​​- All Surfaces and Central Lubrication

• New bearings: fill the bearings until the grease is just visible. Depending on use, after about a week, due to air formation in the bearing housing, lubricate until the pressure has built up.
• Old bearings: If possible, lubricate until filled with new grease, then follow procedure for new bearings.
• General: reduces the lubrication frequency by a factor of 3 to 5 compared to normal lubrication.

Specifications
Colour	Beige
Density at 20°C (IPPM-CS/03)	0.9 g/ml
NLGI ( ASTM D217 )	2
thickener	lithium complex
Type b base oil	Mineral oil
Dropping point (IP 396)	>270 °C
Base oil viscosity at 40ºC (ISO 12058 )	210 cst
Base oil viscosity at 100ºC (ISO 12058)	18 cst
4 ball welding test (DIN 51350:4)	3000 N
Temperature range	-30 until 1 4 0 °C
Peak temperature	220°C
Penetration 60 strokes (ISO 2137)	max. 295mm /10
Penetration 100,000 strokes (ISO 2137)	+30mm/10
SKF Emcor WWO Distilled W ater (ISO 11007mod)	0-0
SKF Emcor WWO salt water (ISO 11007mod)	2-3
Copper corrosion (ASTM D4048)	1a 24h/100°C
Water resistance (DIN 51807/1)	1-90
Oil separation 168 hours at 40°C (IP 121)	2%
SKF R2F test A	Satisfies
SKF R2F test B at 1 4 0 °C	Satisfies
4 ball wear 1 hour at 400 N (DIN 51350:5)	0.8mm

• Suitable for temperatures up to 150°C.
• The product must be tested for miscibility with certain Li and Ca fats.

400 grams = cartridges
10 kg = 1 bucket of 10 kg
25 kg = 1 drum of 25 kg
50 kg = 1 drum of 50 kg
100 kg = 2 drums of 50 kg

For more packaging options, please email our customer service customer.service@vossenlaboratories.com